Rear Housing Assembly (Cont.) -726030452

TM 9-2320-360-34-2

NOTE

When properly assembled, yoke should be stiff, but loose enough to be moved

by hand.

If yoke Is too tight in housing, add or remove shims until correct preload is

obtained.

(10) Install bearing cone (16), bearing cup (17), bearing spacer (18), and preformed packing (19) in pump

housing (2).

NOTE

Shims must be adjusted only If new bearings are installed.

If shim thickness is greater than 0.02 in., another shim must be added to

opposite side of yoke to reduce total shim thickness to less than 0.02 in. Shim

thickness at either pintle must not exceed 0.02 in.

(11) Install shim kit (20) and pintle cover (21 ) on pump housing (2) with four screws (22). Cross-tighten to 175-

185 lb-in. (237-251 Nm).

(12) Install bearing cone (23), bearing cup (24), bearing spacer (25), and new preformed packing (26) in pump

housing (2).

(13) Install shim kit (27) and pint le cover (28) on pump housing (2) with four screws (29). Cross-tighten to 175-

185 lb-in. (237-251 Nm).

27-19