 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
27-2. STEERING PUMP REPAIR (CONT)
(11) Install bearing cone (19), bearing cup (20),
bearing spacer (21), and new preformed
packing (22) in pump housing (2).
(12) Install shim kit (23) and pintle cover (24)
on pump housing (2) with four screws
(25). Cross-tighten to 175-185 lb-in. (237-
251 Nm).
(13) Install spring washer (26), spring (27), and
spring washer (28) in cylinder block (29).
(14) Position four washers (30), screw (31),
and nut (32) through cylinder block (29).
NOTE
Tighten nut only enough to install
retaining ring.
(15) Tighten nut (32) to compress spring (27).
WARNING
Wear eye protection and use care
when installing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(16) Install retaining ring (33) in cylinder block
(29).
(17) Remove nut (32), screw (31), and four
washers (30).
27-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals