 |
|||
|
|
|||
|
Page Title:
Rear Housing Disassembly (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
27-2. STEERING PUMP REPAIR (CONT)
(32) Remove shaft (65), yoke (66), and bearing
(67) from pump housing (14).
(33) Remove seat (68) and spring (69) from
pump housing (14).
NOTE
Do Step (34) if seat fails inspection.
(34) Remove seat (70) and roll pin (71) from
yoke (66).
NOTE
Do steps (35) and (36) if bearing fails
inspection.
(35) Position shaft (65) in press with wide edge
of bearing (67) down.
(36) Press bearing (67) from shaft (65).
(37) Remove two screws (72), washers (73),
pump housing (14), coupler (74), and
preformed packing (75) from pump
housing (76). Discard preformed packing.
WARNING
Wear eye protection and use care
when removing retaining rings.
Retaining rings are under spring
tension and can act as projectiles
when released causing severe eye
injury.
(38) Remove retaining ring (77) from housing
(14). Discard retaining ring.
(39) Remove seal (78) from housing (14).
Discard seal.
(40) Remove bearing race (79) from housing
(14).
27-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals