 |
|||
|
|
|||
|
Page Title:
Rear Housing Disassembly (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
WARNING
Cylinder block spring must be held
by screw, washers, and nut before
removing retaining ring. Spring and
retaining ring are under high tension
and can act as projectiles when
released.
Failure to comply may
result in injury to personnel.
CAUTION
Do not clamp on flat surface of
cylinder block.
Failure to comply
may result in damage to machined
surface.
(22) Position cylinder block (38) in soft-jawed
vise.
(23) Position four washers (44), screw (45),
and nut (46) through cylinder block (38).
(24) Tighten nut (46) and remove retaining ring
(47).
(25) Loosen nut (46) to relieve spring tension.
(26) Remove nut (46), four washers (44) and
screw (45) from cylinder block (38).
(27) Remove spring washer (48), spring (49),
and spring washer (50), from cylinder
block (38).
(28) Remove four screws (51), pintle cover
(52), and shim kit (53) from pump housing
(14).
(29) Remove preformed packing (54), pintle
bearing spacer (55), bearing cup (56), and
bearing cone (57) from pump housing
(14). Discard preformed packing.
(30) Remove four screws (58), pintle cover
(59), and shim kit (60) from pump housing
(14).
(31) Remove preformed pac king (61), pintle
bearing spacer (62), bearing cup (63), and
bearing cone (64) from pump housing
(14). Discard preformed packing.
27-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals