|
|
TM 9-2320-360-34-2
25-3. AXLE NO. 3 DIFFERENTIAL REPAIR (CONT)
WARNING
On direct contact, uncured silicone
sealant irritates eyes.
In case of
contact, flush eyes with water and
seek medical attention. In case of
skin contact, wipe off and flush with
water.
(62) Coat front housing (43) sealing surface
with silicone adhesive-sealant.
WARNING
Adhesive-sealant can burn easily,
can give off harmful vapors, and is
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well ventilated
area. If adhesive sealant gets on skin
or clothing, wash immediately with
soap and water.
(63) Coat threads of five screws (50) and
screw (51) with adhesive-sealant (Item 6,
(64) Install shim (49) and seal cover (48) on
front housing (43) with five screws (50)
and screw (51). Torque screws (50) to 44
lb-ft (60 N m) and screw (51) to 56 lb-ft
(104 Nm).
NOTE
Oil seal is installed properly when top
surface of seal is 1/16 in. (1.59 mm)
below cover.
(65) Install new yoke seal (52) in seal cover
(48).
(66) Coat splines of input shaft (53) with
silicone adhesive-sealant.
(67) Install yoke (54) and new pinion nut (55)
on input shaft (53) using socket (55.1).
Torque to 680-796 lb-ft (922-1079 N m)
using yoke holder (56) with aid of
assistant.
(68) Stake edges of new nut (55) in notches of
shaft (53).
(69) Install two grease fittings (57) on cover
(58).
25-52 Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |