 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(38)
Install lifting eye (57) in input shaft
assembly (54).
WARNING
Input shaft weighs 110 lb (50 kg).
Stay clear of input shaft when
supported by lifting device. Input
shaft may fall and cause serious
injury to personnel.
NOTE
Inner detent ball will fall out of
bottom of transfer case rear half
when upper shift rod is removed.
Fork
assembly
and
shaft
assembly must be removed
simultaneously
to
prevent
binding.
Spacers are different in length.
Mark for proper assembly.
(39)
Remove input shaft assembly (54), upper
shift fork assembly (61), and two spacers
(62) and 63) from transfer case rear half
(2) while assistant operates suitable lifting
device.
(40)
Remove inner spring (64) from transfer
case rear half (2).
(41)
Remove six screws (65) and washers (66)
from transfer case rear half (2).
(42)
Using soft-faced hammer, remove bearing
support (67) from transfer case rear half
(2).
WARNING
Lower rear output shaft weighs 110 lb
(50 kg). Stay clear of output shaft
when supported by lifting device.
Lower rear output shaft may fall and
cause serious injury to personnel.
(43)
Remove lower rear output shaft assembly
(68) from transfer case rear half (2).
NOTE
Do step (44) if bearing or race fail
inspection.
(44)
Remove outer race (69) from bearing
support (67).
23-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals