23-2. TRANSFER CASE REPAIR (CONT)
Place clean shop rag between center
shaft assembly (53) and input shaft
Remove two screws (55) and retainer
plate (56) from end of center shaft
Remove shop rag.
Install lifting eye (57) on center shaft
Center shaft weighs 140 lb (64 kg).
Stay clear of center shaft when
supported by lifting device. Center
shaft may fall and cause serious
injury to personnel.
Remove center shaft assembly (53) from
transfer case rear half (2) while assistant
operates suitable lifting device.
Check that eight spring disks and
spacer are removed with lower shift
Remove lower shift fork assembly (58)
with spacer (59) and eight spring disks
(60) from transfer case rear half (2).