 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
22-16. PLANETARY GEARING, SHAFTS, AND THIRD CLUTCH REPAIR (CONT)
d. Assembly
Rear Carrier
(1) Position rear carrier assembly (1) in press.
(2) Install bearing (2) in pinion (3).
(3) Place new thrust washers (4 and 5) on
opposite ends of pinion (3).
(4) Place pinion (3) with bearing (2) and
washers (4 and 5) in slot at splined end of
carrier (1).
(5) Insert spindle (6) with locking ball (7) in
bore through washers, pinion, and
bearings. Align locking ball with slot in
carrier (1) and press spindle until it seats.
(6) Repeat steps (1) thru (5) to install
remaining three spindles and associated
parts.
(7) Press new spring pin (8) In hole 0.330-
0.370 in. (8.38-9.40 mm) above the face
of carrier.
WARNING
Wear eye protection and use care
when Installing snap rings. Snap
rings are under spring tension and
can act as projectiles when released
causing severe eye Injury.
(8) Install spindle retaining snap ring (9) in
groove in carrier (1).
22-90.2 Change 3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals