 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-360-34-2
(9) Turn rear carrier assembly (1) over in
press.
CAUTION
Short bearing must be toward front
end of carrier to align with lubrication
holes in spindle pin.
NOTE
Bearings (10 and 11) are different,
thrust washers (13 and 14) are the
same.
(10) Install bearing (10) and bearing (11) in
pinion (12).
(11) Place new thrust washers (13 and 14) on
ends of pinion (12).
(12) Place pinion (12) with washers (13 and
14) and bearings (10 and 11) in their
location in slot at rear end of carrier (1).
(13) Insert spindle (15) with locking ball (16) in
bore through washers, pinion, and
bearings. Align locking ball with slot in
carrier (1) and press spindle until it seats.
(14) Repeat steps (9) thru (13) to install
remaining three spindles and associated
parts.
(15) Press new spring pin (17) in hole 0.330-
0.370 in. (8.38-9.40 mm) above the face
of carrier.
WARNING
Wear eye protection and use care
when Installing snap rings. Snap
rings are under spring tension and
can act as projectiles when released
causing severe eye Injury.
(16) Install spindle retaining snap ring (18) in
groove in carrier (1).
(17) Install bearing
(19)
on
rear
carrier
assembly (1).
22-91
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals