TORQUE CONVERTER HOUSING/FRONT SUPPORT REPAIR (CONT) -726030207

TM 9-2320-360-34-2

22-7.

TORQUE CONVERTER HOUSING/FRONT

SUPPORT REPAIR (CONT)

(2)

Set torque converter housing (5) on wooden

blocks.

NOTE

Pin is properly installed when its

head is 0.300 in. (7.62 mm) above

housing surface.

(3) Install spring (6), shifter valve (7), and pin (8) on

torque converter housing (5).

(4) Install new gasket (9) on torque converter

housing (5).

(5) Align holes and install front support assembly

(10) on torque converter housing (5).

(6) Install three screws (11) in front support

assembly (10). Torque to 36-43 Ib-ft (49-58

Nm).

(7) Install 11 screws (12) in front support assembly

(10). Torque to 36-43 Ib-ft (49-58 Nm).

(8) Install screw (13) in front support assembly (10).

Torque to 36-43 Ib-ft (49-58 Nm).

CAUTION

Keep valve clean and free from nicks

and burrs. Failure to comply will

result in difficulty in assembly.

(9) Install main pressure regulator valve (14) small

end first in front support assembly (10).

(10) Install main pressure regulator valve spring (15)

and valve stop (16) in front support assembly

(10).

22-30 Change 1