TORQUE CONVERTER PUMP REPAIR (Cont.) -726030198

TM 9-2320-360-34-2

CAUTION

Failure to use sleeve when tightening

puller may damage transmission

assembly.

(4)

Install sleeve (8), two puller bolts (9),

puller bridge (10), and forcing screw (11)

on pump (12).

(5)

Tighten forcing screw (11) to separate

pump (12) from ground sleeve (3).

(6)

Remove forcing screw (11), puller bridge

(10), two puller bolts (9), and sleeve (8)

from pump (12).

(7)

Remove pump (12) from torque converter

housing (1) and set on level surface.

Disassembly

(1) Bend remaining corners of 6 lockstrips (1)

away from heads of 10 screws (2).

(2) Remove 10 screws (2), 6 lockstrips (1),

and 2 bearing retainers (3) from torque

converter pump (4). Discard lockstrips.

(3) Remove torque converter hub (5) from

pump (4).

(4) Remove two seal rings (6 and 7) from hub

(5). Discard seal rings.

(5) Remove outer race (8) and bearing (9)

from pump (4).

(6) Remove inner race (10) from pump (4).

Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and

clothes, and don't breathe vapors. DO NOT use near open flame or excessive heat.

The flash point is 100-138F (38-59C). If you become dizzy while using cleaning

solvent, get fresh air immediately and medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

(1)

Clean metal parts with dry cleaning solvent.

22-21