FLYWHEEL ASSEMBLY/LOCKUP CLUTCH REPAIR (CONT) -726030189

TM 9-2320-360-34-2

22-4. FLYWHEEL ASSEMBLY/LOCKUP CLUTCH REPAIR (CONT)

(2)

Place wooden blocks on ground.

(3)

Position flywheel (2) on blocks with piston

(3) facing down.

(4)

Lift flywheel (2) 12 in. (30 cm) with aid of

assistant. Drop flywheel (2) on wooden

blocks to free piston (3). Remove piston

(3).

(5)

Remove seal ring (4) from outer groove in

piston (3). Discard seal ring.

(6)

Remove seal ring (5) from outer groove in

flywheel hub (6). Discard seal ring.

NOTE

Do step (7) if pins fail inspection.

(7)

Remove six pins (7) from flywheel (2).

(8)

Set torque converter turbine (8) on level

surface with bearing shaft (9) facing up.

NOTE

Bearing may stay in bore of flywheel.

(9)

Remove bearing (10) from bearing shaft

(9) while assistant holds down torque

converter housing (8).

Cleaning/Inspection

WARNING

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and

clothes, and don't breathe vapors. DO NOT use near open flame or excessive heat.

The flash point is 100-138 F (38-59 C). If you become dizzy while using cleaning

solvent, get fresh air immediately and medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

(1)

Clean all metal parts with dry cleaning solvent

22-12