 |
|||
|
|
|||
|
Page Title:
CAMSHAFT AND END BEARING REPAIR (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
19-12. CAMSHAFT AND END BEARING REPAIR (CONT)
(11) Place lower half (9) of three intermediate
bearings (10) together with top half (11).
(12) Install six lock rings (12) over three
intermediate bearings (10).
(13) Measure and record inside diameter of
three intermediate bearings (10).
(14) Take measurement recorded in step (7)
and subtract from measurement recorded
in step (13).
(15) Replace three interme diate bearings (10)
if clearance exceeds 0.009 in. (0.23 mm).
(16) Inspect spacers (13) and oil seal (14).
Replace if damaged.
(17) Inspect two camshaft gears (15) for worn
or damaged teeth. Replace if damaged.
(18) Place camshaft end bearing journals (6) in
V blocks and use magnetic dial indicator
(16) to check center bearing surface for
runout. Runout should not exceed 0.002
in. (0.05 mm).
(19) If runout exceeds 0.002 in.
(0.05 mm),
replace camshaft.
(20) Repeat steps (1) thru (19) for other
camshaft.
19-106
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals