 |
|||
|
|
|||
|
Page Title:
CAMSHAFT AND END BEARING REPAIR (Cont.) |
|
||
| ||||||||||
|
|
 TM 9-2320-360-34-2
d. Assembly
WARNING
Adhesive-sealant can bum easily, can
give off harmful vapors, and Is
harmful to skin and clothing. To
avoid Injury or death, keep away from
open fire and use In well ventilated
area. If adhesive sealant gets on skin
or clothing, wash Immediately with
soap and water.
(1) Coat sides of two camshaft plugs (1) with
adhesive-sealant.
NOTE
Camshaft plugs should be installed
to a depth of 1.9402.060 In. (49.28-
52.32 mm).
(2) Install two plugs (1) in end of camshafts
(2).
NOTE
Steel faces of thrust washers are next
to bearing.
(3) Coat steel faces of two thrust washers (3)
with grease.
(4) Position thrust washer (3) against each
end of camshaft rear end bearing (4).
(5) Coat camshaft rear bearing Journal (5)
with lubricating oil.
(6) Install two thrust washers (3) and
camshaft rear end bearing (4) on
camshaft (2).
(7) Install woodruff key (6) in keyway at rear
of camshaft (2).
(8) Align camshaft gear (7) with key (6).
(9) Press gear (7) onto shoulder of camshaft
(2).
(10) Repeat steps
(3)
thru
(9)
for
other
camshaft.
(11) Install nut (8) on left camshaft (2). Tighten
finger tight.
19-107
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals