|
| |
TM 9-2320-360-34-1
13-8. STEERING SYSTEM ADJUSTMENT
This task covers:
Adjustment
INITIAL SETUP
Equipment Conditions
Materials/Parts
CPIs in highway mode (TM 9-2320-360-10).
Locknuts (2) (Item 80, Appendix F)
Tires inflated to 75 psi (517 kPa).
Locknuts (2) (Item 103, Appendix F)
Engine shut off (TM 9-2320-360-10).
Lockwashers (2) (Item 106, Appendix F)
Parking brake on (TM 9-2320-360-10).
Pins, Cotter (2) (Item 219, Appendix F)
Wheels straight ahead.
Pins, Cotter (2) (Item 221, Appendix F)
Pins, Cotter (2) (Item 223, Appendix F)
Tools and Special Tools
Tool Kit, Genl Mech (Item 202, Appendix E)
Special Environmental Conditions
Jack, Floor (Item 90, Appendix E)
HET Tractor parked on hard, level surface.
Jack Kit, Hydraulic Hand (Item 92,
Appendix E)
Personnel Required
Jackstands (5) (Item 93, Appendix E)
Three
Plates, Steel (2) (Figure C-13, Appendix C)
Socket, 33 mm, 3/4 In. Drive (Item 163,
Appendix E)
Square, Combination, Protractor Head
(Item 180, Appendix E)
Tape, Measuring, 12 Ft (Item 189, Appendix E)
Wrench Set, Socket, 3/4 In. Drive (Item 231,
Appendix E)
Wrench, Torque, 0-175 Lb-Ft (Item 236,
Appendix E)
a.
Toe-In Adjustment
(1)
Start engine (TM 9-2320-360-10).
(2)
Drive HET Tractor straight back about 20 ft (6 m), then straight forward about 20 ft (6 m). Park with wheels
straight.
(3)
Shut off engine (TM 9-2320-360-10).
(4)
Chock wheels (axle no. 2 or axle no. 3).
(5)
Manually release both spring brakes on axle no. 4 (TM 9-2320-360-10).
Change 1 13-39
|
