|
| |
TM 9-2320-360-34-1
NOTE
If steering pump is being replaced
with a new steering pump, remove
shipping plugs from new steering
pump and install them in old steering
pump. Do steps (32) and (33) to
reinstall old hose and elbow on old
steering pump.
(32)
Install hose (38) on fitting (40).
(33)
Install hose (38) on elbow (39).
b.
Cleaning/lnspection
(1)
Clean old gasket material from engine and steering pump mounting flange.
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and don't breathe vapors. DO NOT use near open flame or excessive heat.
The flash point is 100-138° F (38-59°C). If you become dizzy while using cleaning
solvent, get fresh air immediately and medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
(2)
Clean sealant residue from threaded holes with dry cleaning solvent.
(3)
Inspect drive hub, drive plate, mounting flange, housing, and end plate for damage.
(4)
Apply light coat of grease to splines of drive couplings.
Change 1 13-31
|
