|
| |
TM 9-2320-360-34-1
b.
Installation
WARNING
Support drag link during installation
to prevent it from falling. Failure to
comply may result in injury.
(1)
Install rear of drag link (1) in axle steering
arm (2).
(2)
Install nut (3) on drag link (1). Torque nut
(3) to 165 lb-ft (224 Nm). Continue to
tighten until slot in nut (3) is aligned with
hole in drag link.
(3)
Install new cotter pin (4) through nut (3)
and drag link (1).
c.
Follow-On Maintenance
(1)
Install front pitman arm (para 13-4).
(2)
Lubricate drag link (LO 9-2320-360-12).
(3)
Adjust steering system (para 13-8).
(4)
Start engine (TM 9-2320-360-10).
(5)
Road test vehicle to check for proper operation of steering.
(6)
Shut off engine (TM 9-2320-360-10).
13-3
|
