|
| |
TM 9-2320-360-34-1
10-4. AXLE NO. 4 REPLACEMENT
This task covers:
a. Removal
c. Follow-On Maintenance
b. Installation
INITIAL SETUP
Equipment Conditions
Tools and Special Tools (Cont)
Brake drums removed (axle no. 4 only)
Wrench, Combination, 1-1/2 in. (Item 214,
(TM 9-2320-360-20).
Appendix E)
Differential and wheel ends drained (axle no. 4
Wrench, Impact, Electric, 1 in. (Item 223,
only) (LO 9-2320-360-12).
Appendix E)
Air springs removed (axle no. 4 only)
Wrench, Open-End, 1-11/18 in. and 1-7/8 In.
(TM 9-2320-360-20).
(Item 225, Appendix E)
Shock absorbers removed (axle no. 4 only)
Wrench, Torque, 0-600 Lb-Ft (Item 233,
(TM 9-2320-360-20).
Appendix E)
Propeller shaft removed (axle no. 3 to axle
no. 4) (TM 9-2320-360-20).
Materials/Parts
Lateral torque rod removed (para 15-3).
Adhesive-Sealant (item 8, Appendix B)
Caps, Shipping and Sealing (Item 13, Appendix B)
Tools and Special Tools
Oil, Lubricating (Item 48, Appendix B)
Tool Kit, Genl Mech (Item 202, Appendix E)
Ties, Cable, Plastic, (item 60, Appendix B)
Adapter, Socket Wrench, 1/2 in. Female -
Bolt Kit, Beam Hanger (Item 3, Appendix F)
3/4 In. Male (Item 3, Appendix E)
Bolt Kit, Bushing (Item 4, Appendix F)
Jack, Floor 10-Ton (Item 90, Appendix E)
Locknuts (2) p tem 87, Appendix F)
Jack Kit, Hydraulic Hand (Item 92, Appendix E)
Pins, Cotter (2) (Item 219, Appendix F)
Jackstands (2) (Item 93, Appendix E)
Pins, Cotter (2) (Item 221, Appendix F)
Lift, Transmission and Differential (Item 95,
Appendix E)
Special Environmental Conditions
Multiplier, Torque (Item 99, Appendix E)
HET Tractor parked on hard, level surface.
Sling, Endless Strap (Item 161, Appendix E)
Wrench Set, Socket, 1 in. Drive (Item 230,
Personnel Required
Appendix E)
Two
Wrench Set, Socket, 3/4 in. Drive (Item 231,
Appendix E)
a.
Removal
NOTE
Left and right mud flaps are removed
the same way. Left mud flap is
shown.
(1)
Remove cotter pin (1) and mud flap
bracket
(2)
from bracket (3). Discard cotter pin.
10-22
|
