|
| |
TM 9-2320-360-34-1
CHAPTER 10
REAR AXLES MAINTENANCE
Contents
Para
Page
Introduction .............................................................................................................................10-1
10-1
Axle No. 2 Replacement ...........................................................................................................10-2
10-2
Axle No. 3 Replacement ..........................................................................................................10-3
10-12
Axle No. 4 Replacement ..........................................................................................................10-4
10-22
Axle Alignment .........................................................................................................................10-5
10-33
Axles No. 2, 3, and 4 Oil Seal and Yoke Replacement ...............................................................10-6
10-37
Axle No. 3 Locking Cylinder Replacement/Adjustment ...............................................................10-6.1
10-38.1
Axle No. 4 Pivot, Spindle, and Axle Shaft Repair .......................................................................10-7
10-39
Axle No. 2 and Axle No. 3 Spindle and Axle Shaft Repair .........................................................10-8
10-49
Section I. INTRODUCTION
10-1. INTRODUCTION
This chapter contains maintenance instructions for replacement and repair of axle no. 2, axle no. 3, and axle no. 4 at the
Direct Support maintenance level. Some subassemblies and parts must be removed before the axles and components
can be removed. They are referenced to other paragraphs of this manual or TM 9-2320-360-20.
Section II. MAINTENANCE PROCEDURES
Change 2 10-1
|
