|
| |
TM 9-2320-360-34-1
(2)
Clean sealant residue from threaded holes with dry cleaning solvent.
(3)
Clean all metal parts with dry cleaning solvent.
WARNING
Compressed air for cleaning purposes will not exceed 30 psi (207 kPa). Use only
with effective chip guarding and personnel protective equipment (goggles/shield,
gloves, etc.).
(4)
Dry all parts except bearings with compressed air. Allow bearings to air dry.
(5)
Remove all small nicks or burrs with crocus cloth.
(6)
Coat all parts with light coat of lubricating oil.
(7)
Inspect housing and caps for damage.
(8)
Inspect all parts with machined surfaces for deep scratches or wear grooves.
(9)
Replace all damaged parts.
9-17.1 (9-17.2 blank) Change 1
|
