|
| |
TM 9-2320-360-34-1
b.
Installation
NOTE
Evenly
distribute
any
slack
in
harness.
Do
not
make
any
connections.
(1)
Position DDEC II wire harness (1) on
engine (2) with wire loom (3) and tee (4)
from oil temperature and oil pressure
sensor wires.
(2)
Install electrical connector (5) on oil
pressure sender (6).
(3)
Install wire loom (3) and tee (4) on wire
harness (1) with two clips (7).
(4)
Install wire loom (3) to oil pressure sensor
wire (8) and secure with clip (9).
(5)
Install DDEC II wire harness (1) in
two clips (10) and close clips.
Change 3 6-189
|
