|
| |
TM 9-2320-360-34-1
(6)
Remove plug (10), gasket (11), spring
(12), pin (13), and valve (14) from housing
(7). Discard gasket.
(7)
Remove fuel pump holder (1) from vise.
(8)
Install housing (7) in vise.
(9)
Using oil seal remover (15), remove two
oil seals (16 and 17) from housing (7).
Discard seals.
(10)
Remove two pipe plugs (18) from housing
(7).
c.
Cleaning/Inspection
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and don't breathe vapors. DO NOT use near open flame or excessive heat.
The flash point is 100-138° F (38-59° C). If you become dizzy while using cleaning
solvent, get fresh air immediately and medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
(1)
Clean fuel pump with dry cleaning solvent.
(2)
Inspect parts for damage. Replace damaged parts.
(3)
Inspect mating surfaces of housing and cover. Mating surfaces must be flat and smooth and fit together
tightly.
(4)
Inspect valve. If valve is lightly scored, use crocus cloth to remove marks. If marks cannot be removed
with crocus cloth, replace valve.
4-9
|
