|
| |
TM 9-2320-360-34-1
3-28. ENGINE TESTING (CONT)
NOTE
Do steps (21) and (22) for middle two
cylinders only.
(21)
Remove rubber harness support (43) from
fuel pipes (44).
NOTE
Location of plastic cable ties should
be marked before removal.
(22)
Remove plastic cable tie (18) from fuel
pipe (44) and solenoid valve wire (34).
(23)
Remove two fuel pipes (44) and four seal
rings (45) from injector (46), fuel return
connector (47), and fuel inlet connector
(48). Discard seal rings.
CAUTION
Screws are designed not to be
removed. Loosen screws only two
turns. Failure to comply may result
in damage to injector.
(24)
Loosen two retaining screws (49) and
remove two wire terminals (50) from
injector (46).
NOTE
Rocker arm assembly can be lifted
for easier access to injector screw.
(25)
Remove screw (51), convex washer (52),
and clamp (53) from cylinder head (54)
and injector (46).
(26)
Remove injector (46) from cylinder head
(54).
3-144
|
