|
| |
TM 9-2320-360-34-1
3-20. OIL PAN AND GASKET REPLACEMENT (CONT)
(9)
Remove plug (18) from oil pan (16).
(10)
Remove elbow (19) from oil pan (16).
(11)
Remove STE/ICE oil temperature sensor
(11) and bushing (20) from oil pan (16).
b.
Cleaning/Inspection
(1)
Clean old gasket material from oil pan and
engine block.
WARNING
Compressed
air
for
cleaning
purposes will not exceed 30 psi (207
kPa). Use only with effective chip
guarding and personal protective
equipment (goggles/ shield, gloves,
etc.).
(2)
Clean oil pan with fuel oil. Dry with
compressed air.
(3)
Inspect pan for dents and cracks. Check
for misaligned flanges or raised surfaces
around screw holes by placing pan on
large flat surface. Replace pan if
damaged.
c.
Installation
WARNING
Pipe thread sealing compound can
burn easily, can give off harmful
vapors, and is harmful to skin and
clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If pipe thread
sealing compound gets on skin or
clothing, wash immediately with soap
and water.
(1)
Coat threads of STE/ICE oil temperature
sensor (1) and bushing (2) with pipe
thread sealing compound.
(2)
Install STE/ICE oil temperature sensor (1)
and bushing (2) on oil pan (3).
(3)
Coat threads of elbow (4) and plug (5)
with pipe thread sealing compound.
(4)
Install elbow (4) and plug (5) on oil pan
(3).
WARNING
On direct contact, uncured silicone
sealant irritates eyes. In case of
contact, flush eyes with water and
seek medical attention. In case of
skin contact, wipe off and flush with
water.
(4.1)
Cover plug (5) with silicone sealant.
3-118 Change 1
|
