|
| |
TM 9-2320-360-34-1
(32)
Install oil line no. 2630 (12) on air
compressor (56).
NOTE
Plastic
cable
ties
should
be
positioned
in
locations
marked
during removal.
(33)
Secure oil lines no. 2629 (14) and no.
2630 (12) with plastic cable ties (17).
(34)
Install air hose no. 2600 (65) on air
compressor (56).
(35)
Install two guide screws (66) in lower
holes of engine (20).
WARNING
Steering pump weighs approximately
112 lb (51 kg) Properly support
steering pump during installation.
Failure to comply may result in
serious personnel injury.
(36)
Attach suitable lifting device to steering
pump (67).
(37)
Install drive gear (68) and drive coupling
(69) on steering pump (67).
WARNING
Sealing compound can burn easily,
can give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away from
open fire and use in well-ventilated
area. If sealing compound gets on
skin or clothing, wash immediately
with soap and water.
CAUTION
Drive coupling must be aligned with
drive gears on engine. Failure to
comply may result in equipment
damage.
NOTE
Steering pump and mating surfaces
on engine must be clean. Rubber
seal on gasket must face away from
engine.
(37.1)
Apply sealing compound to engine side of
new gasket (70).
(38)
Install gasket (70) and steering pump (67)
on guide screws (66) with aid of assistant.
Change 3-57
|
