|
| |
TM 9-2320-360-34-1
3-3. ENGINE/TRANSMISSION ASSEMBLY REPLACEMENT (CONT)
a.
Removal
NOTE
Vehicle maintenance time can be
reduced by using three personnel on
steps (1) thru (21), (22) thru (54), and
(55) thru (71).
NOTE
· Steps (1 and 2) apply only to
vehicles with DDEC II engines.
· Step (2.1) applies to vehicles with
DDEC III engines.
(1)
Remove nut (1), lockwasher (2), and wire
no. 068 (3) from stud (4) on coolant level
sender (5). Discard lockwasher.
(2)
Remove screw (6), lockwasher (7), and
wire no. 1788 (8) from coolant level
sender (5). Discard lockwasher.
(2.1)
Disconnect connector (8.1) from coolant
level sensor (8.2).
(3)
Disconnect two hood springs (9) from
spring attachment (10).
(4)
Remove eight locknuts (11), screws (12),
and spring attachment (10) from hardlifts
(13 and 14) and hardlift supports (15) with
aid of assistant. Discard locknuts.
3-4 Change 3
|
