Speed/Timing Sensor - Remove and Install

TM 9-2320-312-24-2

Truck Engine

Disassembly and Assembly Section

g00770496

Illustration 249

(1) Electrical connection for injection actuation pressure sensor

(2) Injection actuation pressure sensor

1. Install injection actuation pressure sensor (2).

Tighten the injection actuation pressure sensor

to a torque of 10 2 Nm (90 18 lb in).

g00771142

Illustration 250

(1) Speed/timing sensors

2. Connect plug (1) to injection actuation pressure

(2) Bolt

sensor (2).

(3) Electrical connections for speed/timing sensors

1. Disconnect plugs (3) for speed/timing sensors

i01481228

(1).

Speed/Timing Sensor -

2. Remove bolt (2) that fastens the speed/timing

Remove and Install

sensors to the engine.

SMCS Code: 1907-010; 1912-010

3. Remove speed/timing sensors (1).

Removal Procedure

Installation Procedure

NOTICE

Keep all parts clean from contaminants.

Contaminants may cause rapid wear and shortened

component life.

NOTICE

Note: The speed/timing sensors must be replaced

Care must be taken to ensure that fluids are contained

as a pair.

during performance of inspection, maintenance, test-

ing, adjusting and repair of the product. Be prepared to

collect the fluid with suitable containers before open-

ing any compartment or disassembling any compo-

nent containing fluids.

Refer to Special Publication, NENG2500, "Caterpillar

Tools and Shop Products Guide" for tools and supplies

suitable to collect and contain fluids on Caterpillar

products.

Dispose of all fluids according to local regulations and

mandates.