 |
|||
|
|
|||
|
Page Title:
Table 195. Table For The Cruise Control Kickout Status Screen On The Electronic Service Tool |
|
||
| ||||||||||
|
|
 389
TM 9-2320-312-24-2
Troubleshooting Section
Table 195
Table For The Cruise Control Kickout Status Screen On The Electronic Service Tool
Troubleshooting
Electronic Service Tool
Meaning or Possible Cause
Intermittent vehicle speed signal or lost
Refer to Troubleshooting, "Vehicle Speed
"Vehicle Speed < Limit"
vehicle speed signal.
Circuit - Test".
The Cruise/Idle On/Off switch is turned
Refer to Troubleshooting, "Cruise Control
OFF or the switch circuit has an open circuit
Switch Circuit - Test".
"Switch Turned Off"
condition.
The cruise pause switch is depressed or
Refer to Troubleshooting, "Powertrain Data
"Cruise Control PAUSE
there is an illegal message on the J1939
Link Circuit - Test".
Switch"
data link.
The service brake pedal is depressed or
Proceed with this test procedure.
"Brake Pedal Depressed"
the service brake switch circuit 2 has a
short circuit condition.
The clutch pedal is depressed or the
Refer to Troubleshooting, "Clutch Pedal
clutch pedal switch circuit has an open
Position Switch Circuit - Test".
"Clutch Pedal Depressed"
circuit condition. Also, the switch could be
incorrectly adjusted.
The transmission is not in gear or the
Refer to Troubleshooting, "Neutral Switch
"Neutral"
transmission switch circuit has a short
Circuit - Test".
circuit condition.
Vehicle speed signal is erratic or
Refer to Troubleshooting, "Vehicle Speed
"Bad Vehicle Speed"
intermittent.
Circuit - Test" if a problem with the signal
exists.
The PTO On/Off switch is turned ON or
Refer to Troubleshooting, "PTO Switch
the PTO On/Off switch circuit has a short
Circuit - Test".
"PTO Switch On"
circuit condition.
The Set/Resume switch was held in the
Cruise control cannot be set until the cruise
SET position for more than 15 seconds
control on/off switch is turned to the OFF
(Basic) or there is a short circuit in the
position and then turned to the ON position
"Set Switch Timeout"
switch circuit.
again. If the circuit for the set switch is
suspected, proceed with this test procedure.
The Set/Resume switch was held in the
Cruise control cannot be set until the cruise
SET position for more than 15 seconds
control on/off switch is turned to the OFF
"Resume Switch Timeout"
(Basic) or there is a short circuit in the
position and then turned to the ON position
switch circuit.
again. If the circuit for the resume switch is
suspected, proceed with this test procedure.
Cruise control has not been enabled since
Drive the vehicle in cruise in order to create
"No Occurrence"
the ECM has been powered up.
the problem again.
or
"Not Kicked Out"
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals