|
|
390
TM 9-2320-312-24-2
Troubleshooting Section
Table 196
Table For The Idle Kickout Status Screen On The Electronic Service Tool
Electronic Service Tool
Meaning or Possible Cause
Troubleshooting
Intermittent engine speed signal or lost
Refer to Troubleshooting, "Engine
"No Engine Speed"
engine speed signal.
Speed/Timing Circuit - Test".
The Cruise/Idle On/Off switch is turned OFF
Refer to Troubleshooting, "Cruise Control
or the switch circuit has an open circuit
Switch Circuit - Test".
"Switch Turned Off"
condition.
The cruise pause switch is depressed or
Refer to Troubleshooting, "Powertrain Data
"Cruise Control PAUSE
there is an illegal message on the J1939
Link Circuit - Test".
Switch"
data link.
The service brake pedal is depressed or the
Proceed with the test procedure.
"Brake Pedal Depressed"
service brake switch 2 circuit has a short
circuit condition.
The clutch pedal is depressed or the
Refer to Troubleshooting, "Clutch Pedal
clutch pedal switch circuit has an open
Position Switch Circuit - Test".
"Clutch Pedal Depressed"
circuit condition. Also, the switch could be
incorrectly adjusted.
The vehicle speed has exceeded the Idle
Refer to Troubleshooting, "Vehicle Speed
"Vehicle Speed ≥ Limit"
Vehicle Speed Limit or the vehicle speed
Circuit - Test" if a problem with the signal
signal is erratic or intermittent.
exists.
The transmission is not in neutral or the
Refer to Troubleshooting, "Neutral Switch
"Neutral"
transmission neutral switch circuit has an
Circuit - Test".
open circuit condition.
The PTO On/Off switch is turned ON or the
Refer to Troubleshooting, "PTO Switch
PTO On/Off switch circuit has a short circuit
Circuit - Test".
"PTO Switch On"
condition.
Idle has not been enabled since the ECM
Operate the vehicle in the Idle mode in order
"No Occurrence"
has been powered up.
to create the problem again.
or
"Not Kicked Out"
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |