|
|
TM 9-2320-312-24-2
Troubleshooting Section
The injection actuation pressure sensor measures
Note: Personality Modules with a manufactured date
the pressure of the oil in the high pressure oil
before JUNE 99 require an electrical connector
manifold. The high pressure oil in the manifold is
for the injection actuation pressure sensor to be
used to actuate the injectors and the high pressure
disconnected in order for the "Injection Actuation
oil is used to control the fuel injection pressure.
Pressure Control Valve Driver Special Test" to turn
Fuel injection pressure is based on inputs from
off the driver for the injection actuation pressure
the sensors. The inputs are used by the ECM
control valve. If the connector J204/P204 for
for calculating the fuel injection pressure. The
the injection actuation pressure sensor is not
ECM uses the reading from the injection actuation
disconnected, the voltage test lamp will remain on
pressure sensor in order to control the operation of
when the special test is not active.
the injection actuation pressure control valve.
Results:
Yes
Repair: Replace the harness for the injection
actuation pressure control valve.
STOP.
No
Repair: Temporarily install a test ECM. Repeat
the test step. If this corrects the problem, then
reinstall the old ECM and verify that the problem
reoccurs. Replace the ECM if the problem
reoccurs with the old ECM.
STOP.
i01857920
Injection Actuation Pressure
g00725343
Illustration 129
Sensor - Test
location of the injection actuation pressure control valve
SMCS Code: 1925-081
System Operation Description:
Use this procedure under the following situation:
Use the following information in order to troubleshoot
the system when there is an active code:
164-02 Injection Actuation Pr Sensor Erratic (15)
Note: This procedure can check the accuracy of
the injection actuation pressure sensor against a
pressure gauge.
The following background information is related
to the following procedure:
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |