Rear Seal Carrier (If Equipped)

TM 9-2320-312-24-2

Specifications Section

(7) Wear sleeves

Do not remove the wear sleeves from the seal

group.

(8) Shipping sleeve for the front seal

Install the front seal (3) in the housing. Remove the

shipping sleeve (8). Install the pulley (6).

i00873707

Rear Seal Carrier

(If Equipped)

g00291470

Illustration 37

SMCS Code: 1161

The single lip seal is used for dry applications (A).

The double lip seal is used for wet applications (B).

(1) Carrier housing and flywheel housing

(2) Rear seal

Install the rear seal. Make sure that the rear face of

the seal (2) is 15.4 0.5 mm (0.61 0.02 inch)

from the block's rear face (4).

Note: The original rear seal runs directly on the

crankshaft flange. The original seal assembly does

not contain a wear sleeve. The Service Rear seal

group contains a wear sleeve (7).

g00443494

Illustration 39

(1) Apply 1U-8846 Liquid Gasket to the joint face

of the seal carrier. Spread the liquid gasket

uniformly on the joint face. The seal carrier must

be assembled and tightened to the cylinder

block within ten minutes.

g00291471

Illustration 38

(2) Apply 9S-3263 Thread Lock Compound to the

threads of the eight bolts.

Front crankshaft seal

(3) Front seal

Install the front seal. Make sure that the front face

of the seal (3) is 2.5 0.5 mm (0.10 0.02 inch)

from the front housing (5).

(4) Rear face of block

(5) Front housing

(6) Pulley