Engine Oil Pan

TM 9-2320-312-24-2

Specifications Section

Tighten the bolts to the following

Load at assembled length ........... 51.99 1.9 N

torque. .............................. 31 3 Nm (23 2 lb ft)

(12 0.4 lb)

Start again with bolt (Z) and tighten all remaining

(5) Relief valve plunger

bolts in a counterclockwise sequence.

Diameter of the plunger ..... 17.000 0.013 mm

(0.6693 0.0005 inch)

Tighten the bolts to the following

Bore in the pump body for the

torque. .............................. 31 3 Nm (23 2 lb ft)

plunger ............................... 17.100 0.025 mm

(0.6732 0.0010 inch)

i00873547

Crankcase Breather

i00880101

Engine Oil Pan

SMCS Code: 1317

SMCS Code: 1302

g00330803

Illustration 26

Typical example

(1) Tighten the bolt that holds the breather cap to

the following torque. .. 7 2 Nm (62 18 lb in)

i01574749

g00448568

Water Temperature Regulator

Illustration 25

(1) Tighten the drain plug to the following

SMCS Code: 1355

torque. ........................ 50 5 Nm (37 4 lb ft)

Apply 1U-8846 Liquid Gasket to four areas on the

sealing surface of the oil pan. The areas are marked

location (Y). The areas are at the corners of the oil

pan in the following locations:

connecting joint of the front housing and the front

of the cylinder block

connecting joint of the flywheel housing and the

rear of the cylinder block

Use the following procedure to tighten the bolts for

the oil pan.

g00291249

Illustration 27

Tighten four bolts (X).

Fully open temperature of the water temperature

Start with bolt (Z) and tighten all remaining bolts in

regulator ............................................... 97 C (206 F)

a counterclockwise sequence.