STEERING GEAR, DRAG LINK, AND PITMAN ARM REPLACEMENT

TM 9-2320-312-24-1

STEERING GEAR, DRAG LINK, AND PITMAN ARM REPLACEMENT

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Materials/Parts - Continued

Maintenance Level

Grease, GAA (Item 30, WP 0165 00)

Direct Support

Rag, wiping (Item 51, WP 0165 00)

MAC Reference

Tag, marker (Item 58, WP 0165 00)

Group 110

Pin, cotter (P/N 60-96) (2)

RPSTL Reference

Personnel Required

Group 110, Figure 1

Two

References

Tools and Special Tools

Group 110 Commercial Service Manuals

Tool kit, general mechanic's (Item 35, WP 0166 00)

Shop equipment, field maintenance (Item 27, WP

Equipment Condition

Materials/Parts

Fifth wheel fully lowered (TM 9-2320-312-10)

Cap set, protective (Item 6, WP 0165 00)

Engine shut down

Fluid, hydraulic, petroleum base (Item 25 or 26,

Cab tilted (TM 9-2320-312-10)

WARNING

DO NOT disconnect or remove any hydraulic system line or fitting unless hydraulic system pressure

has been relieved. Tighten all connections before applying pressure. Escaping hydraulic fluid under

pressure can penetrate the skin, causing serious injury.

Search for leaks with a piece of cardboard. Protect hands and body from high-pressure fluids. If an acci-

dent occurs, see a doctor immediately. Any fluid injected into the skin must be surgically removed

within a few hours or gangrene may result.

At operating temperature, hydraulic fluid is hot. Allow hydraulic fluid to cool before disconnecting any

hydraulic lines. Failure to do so could result in serious burns.

Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning may

result in injury to personnel.