 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
STEERING GEAR, DRAG LINK, AND PITMAN ARM REPLACEMENT - CONTINUED
0146 00
REMOVAL
NOTE
Note position of drag link to ensure correct installation.
1.
Remove cotter pin (2) and castle nut (3) and disconnect rear end of drag link (1) from steering arm (4). Discard cotter
pin.
2
1
3
4
NOTE
To assist in ease of installation, place matchmarks between yoke of lower steering column and shaft of steer-
ing gear.
2.
Remove nut (7) and screw (5) and separate yoke (6) at lower end of lower steering column from shaft of steering gear
(10).
WARNING
When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,
transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal
center or safety office for local regulatory guidance. If further information is needed, please contact The
Army Environmental Hotline at 1-800-872-3845.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings after dis-
connecting. Contamination of hydraulic system could result in equipment failure.
0146 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals