 |
|||
|
|
|||
|
Page Title:
|
|
||
| ||||||||||
|
|
 TM 9-2320-312-24-1
REAR AXLE ASSEMBLY REPLACEMENT - CONTINUED
0145 00
INSTALLATION
1.
Install brake chambers (WP 0031 00).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death to
personnel.
2.
Remove rear axle assembly (1) from cribbing. Using floor jack placed under differential, position rear axle assembly
under rear of vehicle.
3.
Raise rear axle assembly (1) until axle seats contact underside of frame (9).
4.
Position two lower axle mounting caps (10) and secure rear axle assembly (1) to frame (9) by loosely and evenly install-
ing eight new bolts (3) and new nuts (2). DO NOT fully tighten bolts.
5.
Install each stabilizer bar (6) to lower axle mounting cap (10) with new bolt (5) and new nut (4). DO NOT fully tighten
nuts.
6.
On each side, install stabilizer bar (6) to frame (9) with new bolt (8) and new nut (7).
7.
Fully and evenly tighten eight bolts (3) to 730 lb-ft (990 Nm).
8.
Fully tighten two nuts (7) and two nuts (4) to 730 lb-ft (990 Nm).
1
10
2,3
9
7,8
4,5
6
0145 00-4
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals