 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-312-24-1
POWERPACK REPLACEMENT - CONTINUED
0138 00
INSTALLATION - CONTINUED
16.
At transmission (20), position spacers (19), tail shaft support spring (18), and spring cap (21) at transmission
mounting bracket (10). Install two bolts (12) and new locknuts (11). Tighten locknuts to 240 lb-ft (325 Nm).
17.
Secure air dryer-to-air compressor air hose (13) to standoff bracket (17) with clamp (14), bolt (16), and nut (15).
18.
Remove support from under transmission (20).
11,12
13
14
17
15,16
18
10
21
19
20
19.
Install crossmember (1) between vehicle frame rails as follows:
NOTE
Reposition and connect any air or fluid hose or electrical wiring at crossmember as required.
a.
Reposition crossmember (1) between left and right frame rails.
b.
On each side, install crossmember (1) to frame with three bolts (6) and nuts (7). Install bolt (8) and (9).
7
6
1
8
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals