FILLING AND BLEEDING

TM 9-2320-312-24-1

CAB TILT HYDRAULIC SYSTEM FILLING AND BLEEDING - CONTINUED

0125 00

FILLING AND BLEEDING

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

CAUTION

Wipe area clean around filler plug opening prior to removing plug. Cap or plug opening after removing plug.

Contamination of hydraulic system could result in equipment failure.

NOTE

Rotate pump handle socket at top of cab tilt pump for access to filler plug.

Remove filler plug (1) from top of cab tilt pump (2).

Fill cab tilt pump (2) to within in (12.7 mm) of top surface of pump. Loosely install filler plug (1).

NOTE

If cab stops in a partially tilted position, release cab tilt button.

Tilting and lowering cab will bleed air from cab tilt hydraulic system.

Tilt cab (TM 9-2320-312-10) to fully tilted position or as far as cab will tilt. Lower cab (TM 9-2320-312-10).

Repeat step 3.

Remove filler plug (1) and check fluid level in cab tilt pump (2) by inserting a "dipstick" down through filler opening

until it touches bottom. Level should be approximately in (6.4 mm) to in (12.7 mm) on "dipstick".

Add hydraulic fluid, as necessary, and repeat steps 3 through 5.

When fluid level has stabilized at correct level (step 5), install and tighten filler plug (1).

END OF WORK PACKAGE

0125 00-2