FUEL PRIMING PUMP ASSEMBLY INSTALLATION

TM 9-2320-312-24-1

FUEL PRIMING PUMP ASSEMBLY/SECONDARY FUEL FILTER MAINTENANCE - CONTINUED

0017 00

FUEL PRIMING PUMP ASSEMBLY INSTALLATION

Install fitting (6), new o-ring seal (3) and elbow (2) to filter base (1).

Install fuel priming pump assembly (11) to cab tilt latch mounting bracket (10) with two new lockwashers (9), screws

(8), and nuts (7).

Connect inlet fuel hose (4) to elbow (2).

Connect outlet fuel hose (5) to fitting (6) at filter base (1).

Install a new secondary fuel filter (Refer to Secondary Fuel Filter Replacement), if not already installed.

Place battery disconnect switch in ON position.

CAUTION

DO NOT loosen fuel lines at fuel manifold when priming fuel system. Engine components may be damaged

and/or loss of priming pressure may occur when fuel lines are loosened.

Prime fuel system (TM 9-2320-312-10).

Start engine (TM 9-2320-312-10) and check for fuel leaks.

SECONDARY FUEL FILTER REPLACEMENT

WARNING

When servicing this vehicle, performing maintenance, or disposing of materials such as engine coolant,

transmission fluid, lubricants, battery acids or batteries, consult your unit/local hazardous waste disposal

center or safety office for local regulatory guidance. If further information is needed, please contact The

Army Environmental Hotline at 1-800-872-3845.

CAUTION

Wipe area clean around all fuel connections prior to disconnecting. Cap or plug all openings after discon-

necting. Contamination of fuel system could result in equipment failure.

NOTE

Use a drain pan to capture any draining fuel. Dispose of fuel in accordance with local policy and ordinances.

Ensure all spills are cleaned up.

0017 00-3