|
| |
TM 9-2320-304-14&P
5-242
Direct Support and General Support Maintenance (Cont)
5-43. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(82) Apply sealing compound (Loctite
242) to threads of screw (122).
(83) Position screw (123), washer (124),
and loop end of wire rope (124) on
right rear roller bracket (67). Do
not tighten screw.
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap
and water.
(84) Apply sealing compound (Loctite
242) to threads of screw (125).
NOTE
Screw is properly installed when head of screw is 0.50 in. (12.7 mm) from surface of short
strut.
(85) Install screw (125), washer (126), washer (127), and spring (128) on short strut (119).
(86) Soldier A support slider arm (113) and
Soldier B position short strut (119) in
long strut (97) and install pin (103) and
quick release pin (105).
(87) Position wire rope (124) through end
loop of spring (128).
Change 1
|
