|
| |
TM 9-2320-304-14&P
5-243
Direct Support and General Support Maintenance (Cont)
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
(88) Apply sealing compound (Loctite 242)
to threads of screw (129).
(89) Position screw (129), washer (130), and
end of wire (124) on right rear roller
bracket (67).
NOTE
Wire must be pulled tight against roller
bracket when installed.
(90) Wrap wire (124) around screw (129)
and under washer (130) and tighten
screws (129) and (122) on right rear
roller bracket (67).
NOTE
Sealing compound is applied to metallic
side of thrust washer.
(91) Apply sealing compound (Loctite 680)
supplied in kit to thrust washer (131).
(92) Apply adhesive (Loctite 409) supplied
in kit to six points in recessed groove
for preformed packing (132).
NOTE
Thrust washer is properly installed with
metallic side to arm.
(93) Install seal (133), preformed
packing (132), and thrust washer (131)
on arm assembly (113).
Change 1
|
