|
| |
TM 9-2320-304-14&P
2-40
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
CAUTION
·
To avoid equipment damage, visually check that main frame cylinders have
completed full retraction.
·
Reduce speed to idle in last 12 in. (31 cm) of travel to prevent damage to cylinders.
(17) Move joystick (6) to LOAD position and hold in this position until main frame cylinders are fully
retracted.
CAUTION
Engine speed must be at idle before using hydraulic selector switch, or damage to
equipment may result.
(18) Turn hydraulic selector switch (5) to MAN H.A. position.
(19) Hold joystick (6) in LOAD position until the hook arm cylinders (7) are fully retracted.
(20) Release joystick (6).
WARNING
Never drive with LHS NO TRANSIT indicator illuminated. An illuminated indicator means
LHS is not fully stowed. The load could break loose causing serious injury or death to
personnel.
(21) Turn hydraulic selector switch (5) to MAN TRANS.
(22) Put PTO ENGAGE switch (3) in OFF position. Make sure indicator light (4) goes off.
|
