|
| |
TM 9-2320-304-14&P
2-39
Operating Instructions (Cont)
CAUTION
Once suspension has been relieved of flatrack load, do not continue in UNLOAD position or
rear of truck could jack up with hook arm and equipment damage may result.
(11) Continue off-loading until flatrack/FRS is on ground and rear suspension is unloaded.
(12) Release joystick (6).
NOTE
·
Engine speed should be set at idle. However, slight increase in engine speed may be
necessary depending on terrain.
·
LHS will only operate when transmission range selector is in N (Neutral).
(13) Set transmission range selector (2) to D (Drive) and release service brake pedal (1).
(14) Move joystick (6) to LOAD position momentarily and then to UNLOAD position to let lift
hook (8) disengage from hook bar (9). Repeat step (14) until lift hook disengages.
(15) Move truck forward approximately 5 ft. (1.5 m).
(16) Stop truck and set transmission range selector (2) to N (Neutral).
|
