|
| |
TM 9-2320-304-14&P
5-142.4
Organizational Maintenance Instructions (Cont)
5-28.1 CONTAINER HANDLING UNIT (CHU) SLIDER ARM ASSEMBLY REPAIR (CONT).
WARNING
Compressed air used for cleaning purposes shall not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.), or
injury to personnel may result.
(2)
Dry parts with compressed air.
(3)
Inspect parts for breaks, cracks, burrs, and sharp edges. Look for unusual signs of wear on
arm.
(4)
Insert thrust washers. Make sure yellow coating is visible over entire wear surface (or thrust
washers are not less than 0.0795 in. [0.202 cm] thick). If yellow coating is worn, replace with
new thrust washers.
(5)
Replace all damaged parts.
d. Assembly.
(1)
Install grease fitting (1) and grease
fitting (2) in arm assembly (3).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
(2)
Apply sealing compound to threads of
four screws (4).
NOTE
Install quantity of shim(s) as noted during
disassembly.
(3)
Install handle (5) and four screws (4) on
arm assembly (3).
Change 1
|
