|
| |
TM 9-2320-304-14&P
5-142.3
Organizational Maintenance Instructions (Cont)
(2)
Remove seal (5), preformed packing (6),
and thrust washer (7) from small end of
arm assembly (4). Discard seal and
preformed packing.
NOTE
Note quantity of shim(s) for assembly.
(3)
Remove four screws (8) and handle (9)
from arm assembly (4).
(4)
Remove grease fitting (10) and grease
fitting (11) from arm assembly (4).
c. Cleaning/Inspection.
WARNING
·
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
face shield, and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes; and do not breathe vapors. Keep away from heat or flame. Never
smoke when using solvent. The flashpoint for Type III Drycleaning Solvent is 200_F
(93_C). Failure to do so may result in injury or death to personnel.
·
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If
solvent contacts eyes, immediately flush eyes with water and get immediate medical
attention.
(1)
Clean all metal parts with drycleaning solvent.
Change 1
|
