|
| |
TM 9-2320-304-14&P
4-234.22
Organizational Maintenance Instructions (Cont)
4-53.4 CONTAINER HANDLING UNIT (CHU) SHORT STRUT AND PIN BRACKET
ASSEMBLY REPAIR (CONT).
WARNING
Use care when installing snap and
retaining rings. Snap and retaining rings
are under spring tension and can act as
projectiles when released and could cause
severe eye injury.
NOTE
Beveled edge of spacer faces bearing in
short strut.
(3)
Install ring support (4), spacer (5), short
strut (6), and retaining ring (7) on pin
bracket (2).
(4)
Hook spring (8) on wire (9).
(5)
Soldier A and Soldier B support slider
arm (10) and position short strut (6) in
long strut (11) and install pin (12) and
quick release pin (13).
f. Adjustment.
NOTE
·
Make sure slider arm is deployed.
·
Both flip lock brackets are adjusted
the same way. Right side shown.
(1)
Remove quick release pin (1) and pin (2)
from short strut (3) and long strut (4).
(2)
Soldier A and Soldier B using handle of
arm assembly (5), rotate arm assembly
out and separate short strut (3) from
long strut (4).
(3)
Soldier A holding arm assembly (5) out,
position flip lock (6) up.
Change 1
|
