|
| |
TM 9-2320-304-14&P
4-234.23
Organizational Maintenance Instructions (Cont)
(4)
Measure gap between stop bolt (7) and right rear roller bracket (8).
NOTE
·
If gap is not 3/8 ±1/8 in. (9.5 ±3.2 mm), perform steps (5) and (6).
·
If gap is 3/8 ±1/8 in. (9.5 ±3.2 mm), go to step (8).
·
If dimension of gap is greater than 1.25 in. (3.18 cm) following adjustment or proper
adjustment cannot be done, replace stop bolt with 2.50-in. (6.35 cm) long stop bolt.
(5)
Loosen jam nut (9) and adjust stop bolt (7) as required.
(6)
Tighten jam nut (9) on stop bolt (7).
(7)
If proper adjustment could not be made, repeat steps (3) through (6) using longer bolt.
(8)
Aline long strut (4) with short strut (3).
(9)
Using handle of arm assembly (5), rotate
arm assembly out and release flip
lock (6).
(10)
Position long strut (4) into short
strut (3) and install pin (2) and quick
release pin (1).
(11)
Repeat steps (1) through (10) for left
side.
g. Follow-on Maintenance.
(1)
Lubricate rear slider arm (Para 3-2).
(2)
Remove wheel chocks
(TM 9-2320-279-10).
END OF TASK
Change 1
|
