|
| |
TM 9-2320-304-14&P
4-234.6
Organizational Maintenance Instructions (Cont)
4-53.2 CONTAINER HANDLING UNIT (CHU) SLIDER/PIVOT ASSEMBLY REPAIR
(CONT).
b. Disassembly.
WARNING
Use care when removing snap and
retaining rings. Snap and retaining rings
are under spring tension and can act as
projectiles when released and could cause
severe eye injury.
(1)
Remove retaining ring (1), pivot pin (2),
spacer (3) and slider pivot (4) from
slider (5).
NOTE
Note position of torsion spring prior to
removal.
(2)
Remove locknut (6) from screw (7).
Discard locknut.
WARNING
Use care when removing springs. Springs
are under tension and can act as projectiles
when released and could cause injury to
personnel.
(3)
Push in on end of torsion spring (8) and
remove screw (7) from slider pivot (4).
(4)
Remove locknut (9), screw (10), torsion
spring (8), and pivot lock arm (11) from
slider pivot (4). Release torsion spring
and discard locknut.
(5)
Remove two cotter pins (12),
washers (13), pivot lock slot pin (14),
and pivot lock pin (15) from pivot lock
arm (11). Discard cotter pins.
Change 1
|
