|
| |
TM 9-2320-304-14&P
4-156
Organizational Maintenance Instructions (Cont)
4-30. GENERAL WIRE HARNESS REPAIR (CONT).
WARNING
Tip of removal tool is very sharp. Use
caution when using tool. Failure to comply
may result in injury to personnel.
(c) Insert removal tool into cavity (3) on
connector (1) until seated.
(d) Pull wire (4) back through
connector (1) and remove tool.
NOTE
·
Do step (e) only if old terminal is still
attached to wire.
·
Make cut directly behind damaged
terminal.
(e) Cut terminal (5) and wire seal (6) from
wire (4). Discard terminal and seal.
(2) Assembly.
(a) Insert 1 in. (2.5 cm) of wire (1)
through new wire seal (2).
CAUTION
Strip wire after placing it through seal to
prevent damage to individual wire strands.
(b) Strip end of wire (1) leaving 1/4 in.
(0.6 cm) of bare wire.
(c) Insert new terminal (3) in locating
hole of crimp tool using proper hole
according to the gage of wire (1).
(d) Slide seal (2) down to end of
insulation (4) on wire (1).
|
