|
| |
TM 9-2320-304-14&P
4-155
Organizational Maintenance Instructions (Cont)
(2) Assembly.
(a) Install sleeve (1) over end of
wire (2).
(b) Install contact (3) over end of
wire (2).
(c) Crimp contact (3) securely in place.
(d) Slide outer shell (4) over sleeve (1)
and contact (3).
(e) Be sure no bare wire (2) shows
outside of outer shell (4).
e. Group I Terminal Repair.
(1) Disassembly.
NOTE
·
Connector is removed by gently
prying up on clip and pulling on
connector.
·
All Group I connectors are repaired
the same way. Number of wires in
connector may vary.
·
Both halves of connector are
repaired the same way.
(a) Disconnect connector (1).
(b) Unlatch and open two secondary
locks (2) on connector (1).
|
