|
| |
TM 9-2320-304-14&P
4-157
Organizational Maintenance Instructions (Cont)
NOTE
Wire and seal should be positioned so
larger wings of terminal will crimp around
seal and smaller wings will crimp around
exposed bare wire.
(e) Position wire (1) on terminal (3).
(f) Press handles of crimp tool
together until ratchet releases and
crimp is complete.
(g) Push new terminal (3) and wire (1)
through connector (5) until seated.
(h) Close two secondary locks (6) on
connector (5).
(i) Connect connector (5).
f. Group II Terminal Repair.
(1) Disassembly.
NOTE
·
Connector is removed by gently
prying up on clip and pulling on
connector.
·
All Group II connectors are repaired
the same way. Number of wires in
connector may vary.
·
Both halves of connector are
repaired the same way.
(a) Disconnect connector (1).
(b) Unlatch and remove two secondary
locks (2) on connector (1).
|
